BIOS Enable PXE IP4 on Dell 7040

In order to get the machine to PXE boot it is necessary to do the following:-

       1. Navigate to Settings – Secure Boot – Secure Boot Enabled
          Disable Secure Boot

       2. Navigate to Settings - General – Advanced Boot Options
           Enable Attempt Legacy Boot

        3. Navigate to Settings – System Configuration – Integrated NIC
      Select - Enable w/PXE
      Check the – Enable UEFI Network Stack

Start PXE Boot

Press F12 on boot and then navigate to the IP4 network boot.

Errors

If you see the error:-
PXE-E79: NBP is too big to fit in free base memory
You have selected Onboard NIC instead of Onboard NIC ( IPV4) network boot.

Comments

Post a Comment

Popular posts from this blog

Sccm Deploying Problem Driver

Image
Sometimes drivers will not install using sccm's standard driver import so you may have to get a little crazy and create a package that will do the job instead. In this example the problem driver was for AMDA00 Interface device but should work for many other nasty drivers.  Steps to follow to solve the wee issue:- 1. Download driver from windows catalogue if possible, if not what you have will be fine. 2. Import driver manually through compmgmt.msc and selecting to point to driver file manually. 3. Grab driver folder from driverstore in Windows\System32\Driverstore (this will be the new folder by date) 4. Copy driver folder from driverstore to a safe place and delete the driver folder from the driver store. 5. Uninstall driver for problem device so you can test uninstalling and re-installing the driver. 6. Use the following command to install the driver again from the folder you put in a safe place. Pnpuntil.exe /a /i path to .inf file If this works ...
Read more

Dell Latitude 7040 - Enable PXE Boot

Enable PXE Boot In order to get the machine to PXE boot it is necessary to do the following:-              1. Navigate to Settings – Secure Boot – Secure Boot Enabled     Disable Secure Boot         2. Navigate to Settings - General – Advanced Boot Options     Enable Attempt Legacy Boot         3. Navigate to Settings – System Configuration – Integrated NIC                 Select - Enable w/PXE                 Check the – Enable UEFI Network Stack           4. Navigate to Settings - General – Advanced Boot Options                        Boot List Options should be UEFI Start PXE Boot Press F12 on boot and then navigate to the IP4 network boot. Errors If you see the error:- P...
Read more

DWG Trueview 2012

Image
In order to deploy AutoDesk Trueview 2012 for windows 7 you will need to download the source from http://usa.autodesk.com/adsk/servlet/pc/index?siteID=123112&id=9078813. Once you have downloaded the setup files then extract them to your SCCM server using 7 zip.Should look something like below minus the Autodesk.Bat.  Once you have done this make sure you have all the required components on your machine to make it possible to install Trueview 2012. If you dont then download the components you need, in my case I required .Net 4.0. I downloaded the dotNetFx40_Full_x86_x64.exe file and added to my Trueview package under the folder "3rdParty\NET\4\wcu\dotNetFramework\dotNetFx40_Full_x86_x64" You now have all the components you need to complete the install, all that is left to do is create a .bat file to run the .Net 4.0 component then the actual Trueview 2012 install. Below is the command i used within my AutoDesk.Bat:- "3rdParty\NET\4\wcu\dotNetFramework\dotNetF...
Read more